ENGLISH
45
Advanced Setup – Part 1 Advanced Setup – Part 1
ENGLISH
Option Setup
This sets the amount of attenuation applied for audio output
muting.
Setting the Muting Level
• Use this to turn the on screen display (messages other than the
menu screens) “ON” or “OFF”.
• Sets the on screen display mode.
Setting the On Screen Display (OSD)
1
Press the CURSOR
DD
or
HH
button to select “On
Screen Display” at the “Option Setup” menu,
then press the ENTER button.
• The “On Screen Display” screen appears.
2
Press the CURSOR
FF
or
GG
button to select “ON”
or “OFF”.
3
Press the CURSOR
DD
or
HH
button to select the
on screen display mode, then press the CURSOR
FF
or
GG
button to select “MODE1” or
“MODE2”.
4
Press the ENTER button to enter the setting.
• The “Option Setup” menu appears.
MODE1:
Prevents flickering of the on screen display when there is no
video signal.
MODE2:
Flickering is not prevented.
Use this mode if the on screen display does not appear in
MODE1, which may happen depending on the TV being used.
1
Press the CURSOR
DD
or
HH
button to select
“Option Setup” at the “System Setup” menu,
then press the ENTER button.
• The “Option Setup” menu appears.
2
Press the CURSOR
DD
or
HH
button to select
“Muting Level” at the “Option Setup” menu,
then press the ENTER button.
• The “Muting Level” screen appears.
3
Press the CURSOR
FF
or
GG
button to select the
desired setting.
4
Press the ENTER button to enter the setting.
• The “Option Setup” menu appears.
–20 dB:
Attenuation of the volume by –20 dB from the present level.
–40 dB:
Attenuation of the volume by –40 dB from the present level.
– – – dB:
The volume level is completely muted.
Make this setting to switch the power amplifier for the surround
back channel to ZONE2 or Bi-Amp.
Setting the Power Amp Assign.
1
Press the CURSOR
DD
or
HH
button to select
“Power Amp Assign.” at the “Option Setup”
menu, then press the ENTER button.
• The “Power Amp Assign.” screen appears.
2
Press the CURSOR
FF
or
GG
button to select the
Amp Assign mode according to the speaker
system you want to set up.
3
Press the ENTER button to enter the setting.
• The “Option Setup” menu appears.
MAIN ZONE
Surround back 7.1ch system
ZONE2
5.1ch system
Bi-Amp 5.1ch system
Power Amp
Assign.
ZONE2
–
2ch system
–
PRE-OUT
S.BACK/ZONE
Surround back
ZONE2
–
SPEAKER OUT
