A SERVICE OF

logo

Open as PDF
next previous
Back to Contents Page
Display
Dell™Inspiron™1010ServiceManual
Removing the Display Assembly
Replacing the Display Assembly
Removing the Display Assembly
1. Follow the instructions in Before You Begin.
2. Remove the battery (see Removing the Battery).
3. Remove the keyboard (see Removing the Keyboard).
4. Remove the palm rest (see Removing the Palm Rest).
5. Remove the hard drive (see Removing the Hard Drive).
6. Remove the palm rest bracket (see Removing the Palm Rest Bracket).
7. Disconnect the display cable from the system board connector.
8. Disconnect the Mini-Card cables from its connectors.
9. Make note of the Mini-Card cable routing and pull the Mini-Card cables out through the system board so that they are clear of the computer base.
10. Remove the 3-in-1 Media Card Reader (see Removing the Media Card Reader).
11. Disconnect the TV tuner cables from its connectors.
12. Remove the two screws that secure the display assembly to the computer base.
WARNING: Before working inside your computer, read the safety information that shipped with your computer. For additional safety best
practices information, see the Regulatory Compliance Homepage at www.dell.com/regulatory_compliance.
CAUTION: To avoid electrostatic discharge, ground yourself by using a wrist grounding strap or by periodically touching an unpainted metal
surface.
CAUTION: Onlyacertifiedservicetechnicianshouldperformrepairsonyourcomputer.DamageduetoservicingthatisnotauthorizedbyDell™
is not covered by your warranty.
CAUTION: To help prevent damage to the system board, remove the main battery (see Removing the Battery) before working inside the
computer.
CAUTION: To avoid damage to the display, you must not disassemble your Edge-to-Edge display assembly in the field.
1
display cable connector
2
Mini-Card connector cables
3
TV tuner connector cables