Adding and Replacing Parts 121
NOTICE: To prevent damage to the connector, do not use tools to spread the securing clips.
4
If a WLAN card is not already installed, go to step 5. If you are replacing a WLAN card, remove the
existing card:
a
Disconnect the WLAN card from any attached cables.
b
Use your fingertips to carefully spread apart the metal securing tabs until the card pops up slightly.
c
Slide and lift the WLAN card out of its connector.
NOTICE: The connectors are keyed to ensure correct insertion. If you feel resistance, check the connectors and
realign the card.
NOTE: Do not insert a Mobile Broadband card into the WLAN card slot.
NOTE: The WLAN card may have two or three connectors, depending on the type of card you ordered.
5
To install a WLAN card:
a
Move any antenna cables out of the way to make space for the WLAN card.
b
Align the WLAN card with the connector at a 45-degree angle, and press the card into the
connector until you feel a click.
1 WLAN card 2 metal securing tabs (2)
