Po 1 128.2 128 188 FWD(vltI) 0 0 90b1.1cf4.9b79
128.2
Po 2 128.3 128 2000 FWD(vlt) 0 0 90b1.1cf4.9b79
128.3
Te 0/100 128.230 128 2000 FWD 0 0 90b1.1cf4.9b79
128.230
Te 0/103 128.233 128 2000 FWD 0 0 90b1.1cf4.9b79
128.233
Interface
Name Role PortID Prio Cost Sts Cost Link-type Edge
---------- ------ -------- ---- ------- ----------- ------- --------- ----
Po 1 Desg 128.2 128 188 FWD 0
(vltI)P2P No
Po 2 Desg 128.3 128 2000 FWD 0
(vlt) P2P No
Te 0/100 Desg 128.230 128 2000 FWD 0 P2P Yes
Te 0/103 Desg 128.233 128 2000 FWD 0 P2P No
Dell#
mVLT Configuration Example
The following example demonstrates the steps to configure multi-domain VLT (mVLT) in a network.
In this example there are two domains being configured. Domain 1 consists of Peer 1 and Peer 2; Domain
2 consists of Peer 3 and Peer 4 as shown.
Figure 134. mVLT Configuration Example
In Domain 1, configure Peer 1 first, then configure Peer 2. When that is complete, perform the same steps
for the peer nodes in Domain 2. The interface used in this example is TenGigabitEthernet.
Virtual Link Trunking (VLT)
989
