A SERVICE OF

logo

Figure 36. Removing and installing a 1.8 inch (x12) SAS SSD backplane
1. SSD backplane 2. release latch (2)
3. guide pin (6) 4. backplane cable (2)
5. backplane cable connector that connects
to the connector on the system board
6. connector on the system board
(SATA_BP)
7. connector on the expander card (EXP) 8. backplane cable connector that
connects to the connector on the
expander card
Next steps
1. Install the SSD backplane.
Related Links
Installing a 1.8 inch (x12) SAS SSD backplane
Removing the blade
Removing the system cover
99