A SERVICE OF

logo

Open as PDF
next previous
Display Bezel
1. Follow the instructions in "Preparing to Work Inside the Computer."
2. Remove the central control cover.
3. Remove the display assembly.
4. Use a plastic scribe to pry the eight display bumpers out of the screw holes located on the front of the bezel.
5. Remove the eight M2.5 x 6-mm screws located on the front of the bezel.
6. Startingatthebottomofthedisplaypanel(bytheDell™logo),useyourfingerstoseparatethebezelfromthetopcoverbyliftingtheinsideedgeof
the bezel away from the top cover.
Display Panel
1
display
2
display cable connector
3
computer base
4
pull-tab
5
connector
1
display bumpers (8)
4
display panel
2
M2.5 x 6-mm screws (8)
5
top cover
3
display bezel
6
M2 x 3-mm screws (9)
CAUTION: Before performing the following procedures, read the safety instructions in your System Information Guide.
NOTICE: To avoid electrostatic discharge, ground yourself by using a wrist grounding strap or by periodically touching an unpainted metal surface (such
as the back panel) on the computer.
NOTICE: Carefully separate the bezel from the top cover to avoid damage to the bezel.