Installing The Low-Voltage Differential Signaling (LVDS) Camera Cable
1. Secure the low-voltage differential signaling (LVDS) cable to its routing
channel.
2. Replace the adhesives to secure the LVDS and camera cable in place.
3. Connect the LVDS and camera cable to the camera.
4. Install the
display hinge, hinge cap, hinge tower
.
5. Install the
standard display panel
or the
touchscreen display panel
.
6. Install the
standard display bezel
or the
touchscreen display bezel
.
7. Install the
display assembly
.
8. Install the
palm rest
.
9. Install the
hard drive
.
10. Install the
optical drive
.
11. Install the
keyboard
.
12. Install the
keyboard trim
.
13. Install the
base cover
.
14. Install the
battery
.
15. Follow the procedures in
After Working Inside Your Computer
.
Removing The RGB Low-voltage Differential Signaling (LVDS) Cable
1. Follow the procedures in
Before Working On Your Computer
.
2. Remove the
battery
.
3. Remove the
base cover
.
4. Remove the
keyboard trim
.
5. Remove the
keyboard
.
6. Remove the
optical drive
.
7. Remove the
hard drive
.
8. Remove the
palm rest
.
9. Remove the
display assembly
.
10. Remove the
touchscreen display bezel
.
11. Remove the
RGB display panel
.
12. Remove the
display hinge, hinge cap, hinge tower
.
13. Pry up the low-voltage differential signaling (LVDS) cable from the LCD
112
