Dell M4300 Manual

A SERVICE OF

next previous

Back to Contents Page

 Display Assembly

Dell™Precision™M4300ServiceManual

Removing the Display Assembly

Removing the Display Bezel

Removing the Display Panel

Installing the Display Panel

Removing the Display Panel Brackets

Removing the Display Latch

Removing the Display Assembly



1. Follow the procedures in Before You Begin.



2. Remove the hinge cover (see Hinge Cover).



3. Remove the keyboard (see Keyboard).



4. Pull straight up on the pull-tab that is attached to the display-feed flex cable to disconnect the cable from the system board.



5. Disconnect the antenna cable(s).



6. Carefully remove the antenna cable and the display cables from their routing guides.



7. Close the display.



8. Turn the computer upside-down with the back of the computer facing you.



9. From the bottom of the computer, remove the two M2.5 x 5-mm screws labeled "D."

CAUTION: Before performing the following procedures, follow the safety instructions in the Product Information Guide.

NOTICE: To avoid electrostatic discharge, ground yourself by using a wrist grounding strap or by periodically touching a connector on the back panel of

the computer.

1

antenna cable

2

display cable pull-tab



