To change a jumper setting, pull the plug off its pin(s) and carefully fit it down onto the pin(s) indicated.
System Board Jumper Settings
LegacySelect Technology Control
LegacySelect technology control offers legacy-full, legacy-reduced, or legacy-free solutions based on common platforms, hard-drive images, and help desk
procedures.Controlisprovidedtotheadministratorthroughsystemsetup,DellOpenManage™ITAssistant,orDell™custompreinstalledintegration.
LegacySelect allows administrators to electronically activate or deactivate connectors and media devices that include serial and USB connectors, a parallel
connector, a floppy drive, PCI slots, and PS/2 connectors. Connectors and media devices that are deactivated make resources available. You must restart the
computer to effect the changes.
Manageability
Alert Standard Format
ASF is a DMTF management standard that specifies "pre-operating system" or "operating system-absent" alerting techniques. It is designed to generate an
alert on potential security and fault conditions when the operating system is in a sleep state or the system is powered down. ASF is designed to supersede
previous operating system-absent alerting technologies.
The OptiPlex GX60 supports the following ASF version 1.0 alerts and remote capabilities:
NOTICE: Ensure that your computer is turned off and unplugged before you change the jumper settings. Otherwise, damage to your computer or
unpredictable results can occur.
