PowerConnect B-Series FCX Configuration Guide 781
53-1002266-01
IP multicast protocols and IGMP snooping on the same device
25
FIGURE 125 Example 2: IGMP Snooping and PIM Forwarding
CLI commands
The following are the CLI commands for the configuration example shown in Figure 124 and
Figure 125.
1. On the device, configure IGMP Snooping on VLAN 10.
PowerConnect(config)#vlan 10 by port
PowerConnect(config-vlan-10)#untagged e 1 to 4
Added untagged port(s) ethe 1 to 4 to port-vlan 10.
PowerConnect(config-vlan-10)#router-interface ve 10
PowerConnect(config-vlan-10)#ip multicast active
PowerConnect(config-vlan-10)#interface ve 10
PowerConnect(config-vif-10)#ip address 10.10.10.10/24
2. On the device, enable PIM routing between VLAN/VE 20 and Interface e 13.
PowerConnect(config)#vlan 20 by port
PowerConnect(config-vlan-20)#untagged e 21 to 24
Added untagged port(s) ethe 21 to 24 to port-vlan 20.
PowerConnect(config-vlan-20)#router-interface ve 20
PowerConnect(config-vlan-20)#exit
PowerConnect(config)#router pim
PowerConnect(config-pim-router)#exit
PowerConnect(config)#interface ve 20
PowerConnect(config-vif-20)#ip address 20.20.20.10/24
PowerConnect(config-vif-20)#ip pim
Device
(DUT)
Router
Vlan 20
(with VE 20)
e13
Client 10.10.10.1
for 230.1.1.1
Client 40.40.40.1
for 230.1.1.1
erver 10.10.10.100
Server 20.20.20.1
Group 230.1.1.1
e4
e1
e21
Vlan 10
20.20.20.x/24
30.30.30.x/24
40.40.40.x/24
e3
e4
