4
Installing and removing sled components
This section provides information on installing and removing the sled components. For information on
installing and removing the enclosure components, see the enclosure Owner's Manual at dell.com/
poweredgemanuals.
Customer and field replaceable units—PowerEdge FC830
The following components are Customer Replaceable Units (CRUs):
• Cooling shroud
• Memory module
• PCIe mezzanine card
• Internal Dual SD Module (IDSDM) card
• SD vFlash card
• SD cards
• rSPI card
• Network Daughter Card (NDC)
• Hard drives/SSDs
• Hard drive/SSD cage
• System board battery
• 2.5 inch (x8) SAS backplane
• 2.5 inch (x8) SATA backplane
• 2.5 inch (x6) SATA plus 2.5 inch (x2) PCIe backplane
• 1.8 inch (x16) SAS SSD backplane
The following components are Field Replaceable Units (FRUs).
NOTE: Removal and installation procedures of the FRUs should be performed only by Dell certified
service technicians.
• Storage controller card
• Expander card
• System board
• Processors
• Heat sinks
• Trusted Platform Module (TPM)
36
