Back to Removing and Replacing Parts
Palm Rest
Dell™Latitude™E6410/E6410ATGServiceManual
Removing the Palm Rest
1. Follow the procedures in Before Working Inside Your Computer.
2. Remove the ATG Port Cover (applicable on E6410 ATG computer only).
3. Remove the battery.
4. Remove the SIM card.
5. Remove the SD card.
6. Remove the ExpressCard.
7. Remove the Smart card.
8. Remove the hinge covers.
9. Remove the access panel.
10. Remove the optical drive.
11. Remove the hard drive.
12. Remove the LED cover.
13. Remove the keyboard.
14. Remove the coin-cell battery.
15. Remove the memory.
16. Remove the WWAN card.
17. Remove the WLAN card.
18. Remove the LatitudeON™Flash/CMGmodule.
19. Remove the coin-cell battery.
20. Remove the Fingerprint Reader.
21. Remove the Heat Sink and Processor Fan.
22. Remove the Display Assembly.
23. Remove the 8 screws (Number 1 is a captive screw) from the bottom of the computer.
24. Remove the screws that secure the palm rest to the computer.
25. Disconnect the speaker cable (1), power button cable (2), touch pad cable(3), and RFID cable (4).
26. Lift the back edge of the palm rest and pull on the right side to release the right snaps. Once the right snaps release, pull the palm rest forward along
the front to release the front snaps and remove the palm rest.
Replacing the Palm Rest
To replace the palm rest, perform the above steps in reverse order.
Back to Removing and Replacing Parts