A SERVICE OF

logo

Open as PDF
next previous
4. Ground yourself and install the new memory module:
a. Align the notch in the module edge connector with the tab in the connector slot.
b. Slide the module firmly into the slot at a 45-degree angle, and rotate the module down until it clicks into place. If you do not feel the click, remove
the module and reinstall it.
5. Replace the memory module cover.
6. Insert the battery into the battery bay, or connect the AC adapter to your computer and an electrical outlet.
7. Turn on the computer.
As the computer boots, it detects the additional memory and automatically updates the system configuration information.
8. To confirm the amount of memory installed in the computer:
l In the Microsoft
®
WindowsVista™operatingsystem, click Start ® Help and Support® Computer Information.
l In the Microsoft Windows
®
XP operating system, right-click the My Computer icon on your desktop, click Properties, and then click General.
Back to Contents Page
1
memory-module securing clips (2)
2
memory module
NOTICE: Insert memory modules at a 45-degree angle to avoid damaging the connector.
NOTE: If the memory module is not installed properly, the computer may not boot properly. No error message indicates this failure.
NOTICE: If the cover is difficult to close, remove the module and reinstall it. Forcing the cover to close may damage your computer.