Removing and Installing Parts: Dell XPS 600 Service Manual
parts0.htm[4/10/2014 9:50:52 PM]
7. Connect a power cable to the drive.
8. Connect the hard-drive cable to the drive and to the system board.
9. Close the computer cover.
NOTICE: To connect a network cable, first plug the cable into the network port or device and then plug it into your
computer.
10. Connect your computer and devices to their electrical outlets, and turn them on.
See the documentation that came with the drive for instructions on installing any software required for drive operation.
Floppy Drive
CAUTION: Before you begin any of the procedures in this section, follow the safety instructions in the
Product Information Guide.
CAUTION: To guard against electrical shock, always unplug your computer from the electrical outlet before
opening the cover.
NOTE: If you are adding a floppy drive, see "Installing a Floppy Drive."
Removing a Floppy Drive
1. Follow the procedures in "Before You Begin."
2. Disconnect the power and data cables from the back of the floppy drive.
3. Disconnect the other end of the data cable from the system board.
