8 96440 v.10.0
C) Reinstall the rubber hanger onto the
mounted hanger pin assembly.
11. Install the single pin front hanger
clamp onto the rear of the intermediate
pipe with the hanger pin on the inside
facing the muffler. Insert the hanger
pin into the vehicle's rubber grommet.
Install the inlet of the Banks Monster
muffler to the intermediate pipe.
12. For F-series Trucks, install the
dual pin rear hanger clamp onto the
outlet of the Monster muffler with the
hanger pins on the inside, facing the
muffler.
For Excursions, install the rear hanger
clamp with the pins facing to the rear
of the vehicle. Insert the two hanger
pins into the vehicle's rubber
grommets.
13. Route the tailpipe over the rear
axle housing and into the muffler outlet.
Install the tailpipe hanger pin into the
corresponding rubber hanger. Loosely
snug the 4" hanger clamp onto the
muffler outlet.
14. Install the 5" Monster tailpipe tip on
the exhaust. Keep the wrapping on
until installation is complete. The tip
should be rotated so the clamp nut and
drain hole are pointing down. Align the
end of the tip with the body line of the
truck.
15. With everything positioned
properly, begin to tighten the clamps
starting with the ones closest to the
front and working your way back.
Torque the exhaust clamps evenly to
35 ft-lbs. Make sure that each slip is
Figure 4
