10
SAFETY FIRST: To reduce the risk of electrical shock, this fan must be installed with an isolating
SAFETY FIRST: To reduce the risk of electrical shock, this fan must be installed with an isolating
wall control/switch.
SAFETY FIRST: To reduce the risk of electrical shock, this fan must be installed with an isolating
Remove the two screws holding the switch cover plate.
Do not remove the cover plate.
Orient the control bracket as shown and line up the
two inner mounting holes with those on the switch.
Step C. Install and tighten screws using the provided Phillips
in a convenient location.
bracket as shown over the
screws in either the inner
Install and tighten screws
using the provided Phillips
e wall anchors and 6-32 x 1" screws may
be used in situations where mounting to a stud is not
possible. Use the inner mounting holes. After securing
the anchor, discard the anchor’s pointed screws and use
the 6-32 decor ovalhead screws supplied.
CAUTION! Do not use with wall dimmer.
CONTROL BRACKET INSTALLATION
VERSA•TOUCH2™ INSTALLATION
VERSA•TOUCH2™ INSTALLATION HARDWARE
Step A. Break off the two tabs by pushing outward.
Step B. Remove the two screws holding the switch cover
plate. Do not remove the cover plate.
Step C. Orient the control bracket as shown and line up the
two inner mounting holes with those on the switch.
Step D. Install and tighten screws removed in Step B by
