Infotainment System 85
Store Memory Settings
Displayed on Configure Menu
To store memory settings:
1. Be sure the ignition is either on,
in accessory mode, or in RAP.
The vehicle must be stopped
and/or the shift lever must be in
P (Park).
2. Press any button on the
appropriate keyless access
transmitter to identify yourself as
Driver 1 or Driver 2. The
numbers on the back of the
keyless access transmitters
correspond to the driver number.
3. Press CONFIG.
4. Adjust the settings for the driver
seat, the outside mirrors, and
the steering column to a
comfortable driving position or
exit position.
5. Press and hold either the
Driver 1 or Driver 2 screen
buttons to store the driving
positions. Press and hold the
Set Exit screen button to store
the exit position.
Two beeps are heard to confirm
that the driver or exit position is
stored.
The memory settings are now
programmed. Any changes that
are made to the Head-Up
Display (HUD), navigation
system, and climate controls
while driving automatically stores
when then ignition is turned off.
Recall Memory Settings
To recall memory settings:
1. Make sure the ignition is either
on, in accessory mode, or in
RAP. The vehicle must be
stopped and/or the shift lever
must be in P (Park).
2. Press CONFIG.
3. Press and release either the
Driver 1 or Driver 2 screen
buttons to recall the driving
positions. Press and release the
Set Exit screen button to recall
the exit position.
If the vehicle is in P (Park), a
beep is heard and your
previously saved driving position
or exit position is recalled. If the
vehicle is not in P (Park), three
beeps are heard and your
previously saved driving position
or exit position will not be
recalled.
