5
Setup
English FrançaisEspañol
Selecting a location for your system
Your Multi-CD Changer is designed to fit directly under your Wave
®
music system. Before you
connect the Multi-CD Changer to the Wave
®
music system, select a good location for the
complete system using the following guidelines.
• Place the system on a table or other flat surface.
• To enjoy maximum performance, place the system across the room from where you will be
listening.
• Place the system within two feet of a wall, and avoid placing it directly in a corner.
CAUTION:
DO NOT place your system on a heat-sensitive surface. Like all electrical equipment,
it generates some heat.
CAUTION:
DO NOT use your system in a damp location or any other place where moisture can
get inside.
Note:
DO NOT place your system on a metal surface. It could interfere with AM reception.
Seating your Wave
®
music system on the Multi-CD Changer
With the changer placed in your chosen location, carefully set your Wave
®
music system on
top of the changer.
• Make sure the rear feet of the Wave
®
music system fit into the recesses on top of the
changer.
• Make sure the Wave
®
music system sits flat and the side edges of both units are aligned.
