INSTRUCTION FOR USEINSTRUCTION FOR USE
5
– Immerse the mixer attachments into
the mass and choose the desired
speed setting (1). See Chapter SPEED
SETTINGS.
– To prevent splashing, make sure
that the attachments always remain
immersed in the mass while mixing.
– Upon completion of the mixing
process, turn the speed control (1) to
0 and unplug the device.
– If you do not need to use the mixer any
long, place it on the stand (6) with its
four slip-proof silicone feet.
REMOVING THE ATTACHMENTS
– Do not remove the mixer attachments
until you have turned the speed control
(1) to 0 and have unplugged the
device.
– Press the unlock button (2) to remove
the attachments. Make sure that you
hold the attachments by the shaft.
/05& In the interest of your safety, the
attachments can be unlocked only if you
have turned the speed control (1) to 0.
MAINTENANCE AND CARE
– Before you clean the hand mixer,
unplug it.
– Do not use any harsh cleaning
substances.
CLEANING OF ATTACHMENTS
– You can remove any excess food from
the attachments with a spatula made
of rubber or plastic material.
– You can clean the attachments by
hand or in the dishwasher.
– Any repairs have to be performed by an
authorized service center.
CLEANING THE HOUSING
– Use only a moist cloth to clean any
parts of the housing of the mixer.
– Never immerse the motor housing,
mains plug and power cord into water.
Remember, the mixer Is an electrical
device.
STORAGE
– Remove the attachments every time
you are done using the hand mixer.
– While it is not in use, place the mixer
on the stand (6).
/05& Always disconnect the hand mixer
from mains while it is not in use.
