41
APPENDIX A: NVRAM Factory Defaults
Appendix A: NVRAM Factory Defaults
The table below shows, for the ServSwitch Jr. MP’s saveable options, the default
values stored in nonvolatile memory (NVRAM) when the Switch is shipped from
the factory. It also shows what commands or actions can change these settings for
the Switch’s current operating period, as well as what commands or actions can
save changed settings to NVRAM, so that they become the new defaults.
Option Factory-Default To Change To Save
Setting Changes
Caps/Scroll/ Num Lock ON (fixed) Select port, then press the Can’t be saved
Num Lock corresponding button on the
keyboard
Scan OFF Type [CTRL] S (to turn ON) or Can’t be saved
[CTRL] X (to turn OFF)
Scan-Delay 5 seconds Type [CTRL] Txx [ENTER] [CTRL] K
Time (xx = 1 to 15, time in seconds)
Maximum SW627A-R2: Two Type [CTRL] Px [ENTER] [CTRL] K
Ports SW628A-R2: Four (xxx = 2 or 3)
Keyboard Mode 2 Select port, then type [CTRL] Mx [CTRL] K
Mode (x = 1, 2, or 3)
Keyboard 43 (delay of
1
⁄2 second, Type [CTRL] Axxx [ENTER] [CTRL] K
Typematic rate of 10.9 characters (xxx = 0 to 127; see
per second) Section 4.3.11)
Apple Keyboard 0 (standard 104/105-key Type [CTRL] Px [ENTER] [CTRL] K
Emulation mapping) (xxx = 0, 1, or 2)
PS/2 to RS-232 0 (OFF) for each computer Select port, then type
Mouse [CTRL] 1 [ENTER] to turn ON or [CTRL] K
Translation [CTRL] 0 [ENTER] to turn OFF
