724-746-5500 | blackbox.com
Page 10
RM610A-R2
Chapter 3: Mounting Instructions
For a masonry wall surface, the installer must provide the appropriate hardware.
3.4 Loading Equipment
WARNING: Only install equipment after the Server Side-Mount Wall Cabinet has been properly secured and mounted to the wall.
Maximum Load Capacity = 250 lb. (113.6 kg)
3.5 Power
When using power distribution units (PDUs), each PDU should be connected to a committed branch circuit that is rated for the
continuous load of all the equipment connected.
When not using a PDU, each piece of equipment should be connected to a dedicated branch circuit.
3.6 Protective Grounding
A main protective earthing stud and grounding studs are provided.
WARNING: To avoid injury to persons or loss of life, ground each enclosure individually to the dedicated branch circuit earthing
ground.
3.6.1 Connecting Main Protective Grouding Stud to the Dedicated Branch Circuit Earthing Ground
Conductor
Connect the dedicated branch circuit ground conductor to the main protective earthing stud located inside at the bottom rear of
the enclosure chassis using a listed ring or closed-loop terminal.
3.6.2 Connecting Main Protective Grounding Stud to the Protective Bonding Conductors
Connect the rear door to the main protective grounding stud located inside at the bottom rear of the enclosure chassis
using a listed ring or closed-loop terminal. Connect the front door to the grounding stud located inside at the bottom front
of the enclosure chassis using a listed ring or closed-loop terminal.
