Master Hub Configuration & Console Management 87
Link Test: Enable or disable link testing.
Speed Control: The port speed. The port automatically connects
to the 10Mbps or 100Mbps segment based on its port speed.
• Auto Negotiate: The speed is detected and the duplex mode
is forced to half duplex.
• Force 10-TP: The port speed is forced to 10Mbps.
• Force 100-TP: The port speed is forced to 100Mbps.
Link Status Change Notify
• Enable: The trap is sent.
• Disable: The trap is not sent.
NOTE: Whenever the Port Link Status is changed, the
“hubPortLinkStsChgTrap” will be raised by the hub.
2/3 Port Bridge Module Control/Status
This menu displays settings and allows configuring a bridge (switch)
module in a given hub in the stack.
2/3 Port Switch Module Control/Status Menu
