Chapter 3: Configuration
LMC5601C-VDSL2 724-746-5500 | blackbox.com Page 9
Switch # Feature Function Default
1 HOST HOST=OFF / Remote=ON OFF
2 LFPT On= Link Fault Pass-Through Enabled OFF
3 FL ON= Fault Loopback Enabled OFF
4 Band Plan
On= Asymmetric 998 with ISDN
Off= Symmetric 997 with ISDN
OFF
5 AN On= Auto Negotiation ON ON
6 Flow Control On= Flow Control ON ON
7 Selective AN
On= Selectively advertises Speed
Duplex if AN is enabled
OFF
8 Duplex OFF= Full Duplex / ON= Half Duplex OFF
9 Speed On= 100Mbps / Off= 10Mbps OFF
10 Factory Default Factory Default: Do not Use OFF
These features are described in more detail in the following sections.
3.2 Host CO Module Configuration
To allow the HOST (CO) HDMCII VDSL2 LAN Extender Module (Extended
Temp) to manage the remotely connected (CPE) HDMCII VDSL2 LAN
Extender Module (Extended Temp) unit, set DIP Switch #1 to the OFF
position (default setting). This selection can only be performed manually and
cannot be overridden by software settings.
A Host configured CO HDMCII VDSL2 LAN Extender Module (Extended
Temp) must be installed in a managed chassis to allow SNMP management
through iView². The High-Density Media Converter System II chassis series,
available in 3, 6 and 20 slots with an optional SNMP Management Module, is
recommended. Please refer to the section SNMP Management.
3.3 Remote CPE Module Configuration
To configure a CPE HDMCII VDSL2 LAN Extender Module (Extended Temp)
as a Remote CPE, set DIP Switch #1 to the ON position (OFF is the default
setting).
A Remote CPE configured HDMCII VDSL2 LAN Extender Module (Extended
Temp) can be installed in an unmanaged chassis. These chassis can
include Density Media Converter System II chassis with the optional SNMP
agent management module removed.
3.4 DATA Port Features
The 10/100BaseT DATA port on the HDMCII VDSL2 LAN Extender Module
(Extended Temp) Auto Negotiates for speed and duplex mode. These
modules also provide the option of manually setting the speed and duplex
mode if the connected devices do not have the ability to Auto Negotiate, or
