89
A/C-7P RO, A/C-7S RO
Figure 6-9. XY Coordinate System on the Page.
semi-colon “;” as a separator
between parameters, you may
also enter a comma “,” or a
forward slash “/”.
4. Do not enter numeric values
with commas (for example,
50,000). The printer interface
will interpret the “ ,” to be the
end of the parameter (so that
50,000 would be interpreted as
two values: value 1 = 50, value 2 =
000).
International users should also
be aware that a decimal value
used to specify line width (in
mm) such as “1,5” (i.e. 1 1/2) is
also interpreted as two separate
values (i.e. value 1 = 1, value 2 =
5). To enter a valid decimal line
width use the period “.” (i.e. 1.5
mm).
2. The complete command string
must be entered as shown below.
Incomplete command strings
and command strings with
invalid values (such as spaces)
will cause the A/C-7 RO to print
the string at the place where the
error occurred.
For example, a line command
string has been entered.
However, an invalid <x start>
value has been specified.
¬GL30;A;1;1;600
The A/C-7 RO would cause all
characters, including the invalid
value “A” to be printed:
A;1;1;600
3. As an alternative to using the
