www.bissell.com 800.237.7691
Assembly
The only tool you’ll need to assemble
your vacuum cleaner is a Phillips head
screwdriver.
Attach handle to vacuum
1. Locate the bag that contains the extension
wand support, lower cord wrap, and screws.
Remove the screw packet from the bag.
2. Stand the vacuum upright and from the
rear of the unit, slide the base of the
handle firmly into the grooves at the top of
the vacuum body.
3. Ensure that the handle is firmly attached to
the vacuum body. The front of the handle
should be flush with the front of the vacu-
um body. If there are any gaps, continue
to push the handle until it is secure.
4. Remove two of the four screws from the
screw packet. Insert one screw, into each
of the existing holes in the handle. With a
screwdriver, tighten each screw completely.
1. Locate the bag that contains the exten-
sion wand support, lower cord wrap, and
remaining two screws.
2. Attach the extension wand support to the
rear of the unit. Extension wand support
should be placed about half way down
the vacuum body. Using one of the two
remaining screws, insert one screw into the
existing hole. With a screwdriver, tighten
screw completely.
3. Attach the lower cord wrap to the rear of
the unit. Lower cord wrap should be placed
toward the bottom of the vacuum body.
Using the last screw, insert screw into the
existing hole. With a screwdriver, tighten
completely.
4a. Attach Twist ‘n Snap
™
hose by placing the
tabbed end of the hose into the opening
of the unit, located on the left side of the
vacuum (when viewing from the back). Turn
the hose to the right to lock into place.
4b. Place the attachment end of the hose into the
hole on the right side of the unit, near the
wheel.
NOTE: The vacuum will not operate
effectively unless the hose is firmly
attached.
5
Attach storage clips, tool, and vacuum hose
Caution:
Do not plug in your vacuum
cleaner until you are familiar
with all instructions and
operating procedures.
2
4
2
3
4a
4b
