Bell View Video Entry System
10
General
Select the appropriate wiring diagram from one of the following sections, and install in
accordance with the instructions given:
System Section
1 way single door CW1
2-10 way single door CW2
11-60 way single door CW3
1-10 way 2 door CW4
11-60 way 2 door CW5
Initially connect all the equipment to one telephone only. With the power applied, test
the system is fully operational. Only if everything is functioning correctly should you
continue to connect further telephones. Connect one telephone at a time testing after
each is connected.
Model 440 and 540 Power Supplies
Read the section called ‘Important Safety Information’ before installing the power
supply.
These power supplies must be wall-mounted onto plasterboard, wood or a similar non-
conductive material, in a protected indoor environment such as an electrical cupboard.
When fitting the power supply cable (both mains and low voltage) ensure the cable
entry cut-outs in the enclosure lid are no larger than necessary for the cable diameter
used and under no circumstances must they be taken beyond the outer cut-out zones.
