Introduction
1
12
AJA OEM-2K PCI-X Firmware
System configuration is done prior to delivery by an authorized technician. The following
procedures may not be necessary, and are provided here for informational purposes only.
Verifying the AJA OEM-2K PCI-X Firmware
The firmware on your AJA OEM-2K PCI-X (AJA PCI-X) must correspond to the certified
version required by your Effects or Editing application version. If the firmware on your AJA
PCI-X board does not correspond to the table below, you must update it to the certified version.
The AJA PCI-X firmware update utilities required to check your firmware version are included
with the DKU version associated with the release of your Effects or Editing application. The
following procedure describes how to verify the firmware version of the AJA PCI-X.
To verify the AJA PCI-X firmware version:
h Typ e:
cat /proc/driver/aja
An output similar to the following should appear:
N
OTE
:
If there is no
aja
file in /proc/driver, you are using an outdated driver or the driver is not
loaded and you must install the latest DKU for your workstation. Refer to the
Autodesk Effects
and Editing 2008 Software Installation Guide for Linux Workstations
.
Updating the AJA PCI-X Firmware
The firmware on your AJA PCI-X must correspond to the certified version required by your
Effects or Editing application version. If you verified the firmware on your AJA PCI-X and it did
not match the certified version, you must update it. The following procedure describes how to
update the firmware of the AJA PCI-X to the certified version required by your Effects or
Editing application.
Effect or Editing Product Version Certified Firmware Version
2008 0x50
AJA Driver Name: oem2k
Version: 4.1 Beta 9
Card #: 0
Board Version String: OEM 2K - Rev 0
PCI Version: 0x50
Board ID: 10196500
FPGA built on 2006/08/17 at 08:21:11
