A SERVICE OF

logo

Appendix
67
4. Slide the rear attachment sliding brackets along the slide bars until they
contact the rear of the KL1116, then use the screws supplied with this
package to attach the bars to the rear of the KL1116 (tighten the screws all
the way).
5. Slide the KL1116 open and closed a couple of times to be sure that it is
properly aligned and operating smoothly. (See Opening the Console,
page 15 for opening and closing procedures.)
6. After determining that the KL1116 is lined up and operating correctly,
finish by fully tightening the front attachment screws inserted in Step 3.
Phillips I head
M4 x 6