Figure 1 - ATD-7304 Nomenclature
! WARNING
•
Study, understand, and follow all printed
materials provided with/on this product before use.
• Do not exceed rated capacity.
• Use only on hard, level surface.
• This is a lifting device only!
• Immediately after lifting, support the load with
a pair of appropriately rated jack stands.
• Lift only on areas of the vehicle as specified by
the vehicle manufacturer.
•
Do not move or dolly the vehicle while on the jack.
• No alterations shall be made to this product.
• Failure to heed these markings may result in
personal injury and/or property damage.
To avoid crushing and related injuries:
•
Never work on, under or around a load supported
only by hydraulic jack.
•
Always use adequately rated jack stands.
• Chock each unlifted tire in both directions.
• Do not use this device to lift, level, lower, support nor
move a house, mobile home, travel trailer, camper or
any building structure.
• Be alert and sober when using this product. Do not
operate under the influence of drugs or alcohol.
! WARNING
X
3
!
OPERATION
Lifting
Only attachments and/or adapters supplied
by the manufacturer shall be used. Lift only
on area of the vehicle as specified by the vehicle
manufacturer.
1. Follow the vehicle manufacturer’s recommended
guidelines for lifting. Engage the emergency brake
and chock each unlifted wheel in both directions to
prevent inadvertent vehicle movement.
2.
Close release valve by turning it with the stamped end
of handle clockwise until firm resistance is felt.
3. Refer to the vehicle manufacturer owner’s manual to
locate approved lifting points on the vehicle. Center
jack saddle under lift point.
4. Verify lift point, then pump handle to contact lift
point. To lift, pump handle until load reaches desired
height.
5. Transfer the load immediately to appropriately rated
jack stands.
NEVER use hydraulic jack as a stand
alone
device! ALWAYS transfer the lifted load
IMMEDIATELY to a pair of appropriately rated jack
stands. Use one pair of jack stands per vehicle.
Rated capacity is per pair only! Do not exceed rated
capacity.
Lowering
Be sure all tools and personnel are clear before
lowering load. Slowly open the release valve!
The more you turn the handle counter-clockwise, the
faster the load will come down. Maintain control of the
rate of speed at which the load lowers at all times!
1. Raise load high enough to clear the jack stands.
2.
Remove jack stands carefully (always used in pairs).
3. Slowly turn the handle counter-clockwise, but no
more than 1/2 full turn. If the load fails to lower:
a. Use another jack to raise the vehicle high
enough to reinstall jack stands.
b. Remove the malfunctioning jack and then the
jack stands.
c.
Use the functioning jack to lower the
vehicle.
4. After removing jack from under the vehicle, fully
lower the saddle to reduce ram exposure to rust and
contamination.
!
!
Handle
Release
Valve
Oil Filler Plug
(Remove cover
plate to access)
Handle
Sleeve
Rear Caster
Front
Wheel
Lifting Arm
Saddle
