Features:
1. Geared Rotary barrel pump with 3 times discharge
per rotation. For every complete handle turn, the
rotor turns 3 times
2. Compact design, Ideal for use where volume fuel
dispensing is needed, such as construction sites,
workshop, aviation, farms/ ranches, boat etc.
3. Professional Die Cast Aluminum construction with
Die Cast Zinc rotor & vanes
4. Non wearing sintered gears
5. Crank Shaft mounted on ball bearings
6. Die Cast Aluminum handle with security locking latch
7. Horizontal Discharge outlet (easily connects to a Fuel
Filter)
8. Fits 15 to 55 gallon (50 - 205 liter) drums
9. Dispenses 10 liters (2.60 gl.) per 20 turns
Piece Count:
1. Pump Body
2. Crank Fitted with Pump Handle
3. Bung Nut with 2” threads
4. Discharge Spout
5. Suction Tube
6. Discharge Hose Assembly (Includes hose, hose spring,
nozzle & hose clamp)*
*Optional, included only on select models
Intended use with :
Gasoline, Diesel, Kerosene etc. Works with most petroleum
based media & lubricating oils up to SAE 90
Do NOT use with:
Corrosive media, solvents, acids, alkalis etc
Wetted components:
Steel, Aluminum, Zinc, NBR, PVC Nitrile **, Polyacetal***
**on models with hose
*** On models with non-return at inlet of suction tube
Assembly & Operation:
1. Fasten the discharge spout into the pump outlet. Use a thread sealant for a leak proof connection. For
pump models supplied with hose assembly, connect the hose assembly to the end of the discharge
Spout using the hose clamp
2. Loosen the grub screw on the crank & connect the crank to the crankshaft. Secure the connection by
tightening the grub screw. Make sure that the grub screw fits onto the depression in the crankshaft
3. Assemble the suction tube parts, depending on the drum with which the pump is to be used. All 3 parts
must be connected for use with 55 gallon / 205 litre drums. It is good practice to use a sealant such as
Teflon in connecting the suction tube parts for a totally leak-proof connection. Select models may come
with a telescopic suction tube. Such a tube needs no assembly and will automatically adjust to the drum
length
4. Slide the 2” bung nut onto the suction tube from the top end
5. Tighten the suction tube onto the pump inlet. It is good practice to use a sealant such as Teflon in
connecting the suction tube to the pump inlet
6. Insert the pump assembly into the drum from the 2” bung opening on the drum
