Page 9
REMOTE VEHICLE STARTER/ALARM INSTALLATION MANUAL
6 Pin Power Connector
Step1-Connect All Of the Following Wires
Yellow 30amp Starter Output 12volts during start position only.
Green 30amp Heater Output 12volts in the accessory position off during
start and 12volts during run.
Red 30amp Power Input Constant 12volt power at ignition harness
or from battery.
Red 30amp Power Input Constant 12volt power at ignition harness
or from battery.
Blue 30amp Ignition Output 12volts in the ignition, start and when run
positions.
White* 30amp Select Output Selectable Output for vehicles that require
2nd Ign, Acc or Starter wires.
*Note: The white wire may not be required on all vehicles.
14 Pin Connector
Step 2- Plug-In The Module
Black System Ground Input Connect to Chassis Ground.
White Park Light Output Connect to (+) Park Light system.
Green/Wht Hood Pin Input Connect to the Hood Pin Safety Switch.
Blue/Wht Tach Connect To A/C Tach Source.
Pink Brake Switch Connect To (+) When Brakes Is Applied.
Wht/Blue Siren Connect to Siren Positive Activation.
Green* (-) Door Pin Input Connect to door pin (-) when doors opened
Purple* (+) Door Pin Input Connect to door pin (+) when doors opened
* Connect only one of the door pin inputs. If the vehicle has a positive door pin
system connect the purple wire, if negative connect the green wire.
Manual Transmission Connections (”M” Models Only)
Black/Wht Park Brake Input Connect to Park Brake wire.
Never install an automatic module into a manual transmission vehicle!
When all the connections are done, the control module can be plugged in. Before
connecting the control module, make sure the ignition is in the OFF position. Plug
in the 6 pin harness and the Auxiliary harness, then any other connectors that were
used. The park lights will flash and the siren will chirp 2 times to confirm power
up on automatic transmission models. Manual transmission models will flash the
park lights and chirp the siren 4 times to confirm power up.
