Agri-Fab 45-03621 Manual

A SERVICE OF

next previous

19

CUSTOMER RESPONSIBILITIES

CLUTCH CABLE ADJUSTMENT

• RemovefourscrewsfromRearDriveCover.Layaside

cover and screws.

• PlaceClutchLeverin“DISENGAGED"position

• TheCableshouldbeunderslighttensionbutshould

not pull the Clutch Lever more than 1/8" away from the

Switch Body.

NOTE:IfthePlungerextendsmorethan1/8"outfrom

the switch body, the cable tension is too tight and the

Engine will not start.

TO INCREASE CABLE TENSION

• PlaceBladeClutchLeverinthe“DISENGAGED"

position.

• LoosentheinnernutontheClutchCable.

• TightentheouternutontheClutchCable.

TO DECREASE CABLE TENSION

• PlaceBladeClutchLeverinthe“DISENGAGED"

position.

• LoosentheouternutontheClutchCable.

• TightentheinnernutontheClutchCable.

• Repeattheaboveprocedureuntilyouhavethecorrect

tension.

INNER NUT

OUTER NUT

SWITCH

BODY

CLUTCH LEVER

1/8"

ENGINE

PULLEY

BLADE

PULLEY

IDLER

PULLEY

CLUTCH LEVER

PLUNGER

REAR DRIVE

COVER

FOUR

SCREWS