OPERATION MANUAL
NAV-402AP-3
1-4-1
Page 1
Sep 1/04
SECTION 4 - SHIPPING
1. SHIPPING TEST SETS
1.1 INFORMATION
Aeroflex Test Sets returned to factory for
calibration, service or repair must be
repackaged and shipped according to the
following conditions:
AUTHORIZATION
Only return products to factory after first
receiving authorization from Aeroflex Customer
Service Department.
CONTACT: Aeroflex
Customer Service
Telephone: (800) 835-2350
FAX: (316) 524-2623
email: service@aeroflex.com
TAGGING TEST SETS
All Test Sets must be tagged with:
O Identification and address of owner
O Nature of service or repair required
O Model Number
O Serial Number
SHIPPING CONTAINERS
Test Sets must be repackaged in original
shipping containers using Aeroflex packing
molds. If original shipping containers and
materials are unavailable, contact Aeroflex
Customer Service for shipping instructions.
FREIGHT COSTS
All freight costs on non-warranty shipments are
assumed by the customer. (See “Warranty
Packet” for freight charge policy on warranty
claims.)
1.2 REPACKING PROCEDURE
O Make sure bottom packing mold is seated
on floor of shipping container.
O Carefully wrap Test Set with polyethylene
sheeting to protect finish.
O Place Test Set into shipping container,
making sure Test Set is securely seated in
bottom packing mold.
O Place top packing mold over top of Test Set
and press down until mold rests solidly in
bottom packing mold.
O Close shipping container lids and seal with
shipping tape or an industrial stapler. Tie
all sides of container with break resistant
rope, twine or equivalent.
