2 –Pump 18-Station Controllers Chapter 4: Operation 23 of 44
Chapter 4: Operation
4-1 Overview
Your 2-pump, 18-station controller electrically controls valves and solenoids to convey
material from a central location to individual stations as needed. The controller senses
demands for material at the stations and responds to the demands in a timely fashion.
This section gives the procedures for using your controller, and it covers tasks that can be
carried out with no password or with an operator’s password. The section is divided into three
sub-sections:
• Basic tasks: tasks normally carried out by a station operator
• Advanced tasks: tasks normally carried out by setup personnel
• Alarms: silencing and clearing alarms
Note: Before you carry out any of the procedures in this chapter, the system must be set up
as described in the previous chapter.
4-2 Basic Tasks
Reviewing Station Status
The starting point for all operations is the “Station Status” screen. This screen is displayed
when the unit is first powered up or can be reached by touching STATION STATUS in the
Main Menu screen. The “Station Status” screen appears.
Figure 13: “Station Status” Screen During Operation
Note: Press MORE to view the status of stations 10-18.
The status of each station is noted at the top of each icon. See the table on the next page for a
complete list of station operating icon labels.
