Line Commands
4-9
4
The access mode shown in the following tables is indicated by these abbreviations:
PE (Privileged Exec) VC (VLAN Database Configuration)
NE (Normal Exec) MST (Multiple Spanning Tree)
GC (Global Configuration) LC (Line Configuration)
IC (Interface Configuration) ACL (Access Control List Configuration)
Line Commands
You can access the onboard configuration program by attaching a VT100
compatible device to the server’s serial port. These commands are used to set
communication parameters for the serial port or Telnet (i.e., a virtual terminal).
Spanning Tree Configures Spanning Tree settings for the switch 4-150
VLANs Configures VLAN settings, and defines port membership for VLAN
groups; also enables or configures private VLANs and protocol VLANs
4-168
GVRP and
Bridge Extension
Configures GVRP settings that permit automatic VLAN learning;
shows the configuration for the bridge extension MIB
4-181
Priority Sets port priority for untagged frames, selects strict priority or weighted
round robin, relative weight for each priority queue, also sets priority for
TCP/UDP traffic types, IP precedence, and DSCP
4-185
Multicast Filtering Configures IGMP multicast filtering, query parameters, and specifies
ports attached to a multicast router
4-197
IP Interface Configures the IP address and gateway for management access 4-205
DNS Configures DNS services. 4-210
Table 4-5 Line Commands
Command Function Mode Page
line Identifies a specific line for configuration and starts the line
configuration mode
GC 4-10
login Enables password checking at login LC 4-11
password Specifies a password on a line LC 4-12
timeout login
response
Sets the interval that the system waits for a login attempt LC 4-12
exec-timeout Sets the interval that the command interpreter waits until user
input is detected
LC 4-13
password-thresh Sets the password intrusion threshold, which limits the number of
failed logon attempts
LC 4-14
silent-time
*
Sets the amount of time the management console is inaccessible
after the number of unsuccessful logon attempts exceeds the
threshold set by the password-thresh command
LC 4-14
databits
*
Sets the number of data bits per character that are interpreted and
generated by hardware
LC 4-15
Table 4-4 Command Group Index (Continued)
Command Group Description Page
