Filter
Top Products
1. Locknut 2. Chain adjuster 3. Alignment marks
3. After adjusting, be sure to tighten the lock-
nuts and the wheel hub bolts.
EBU00354
Drive chain cleaning and lubrication
The drive chain is equipped with rubber O-rings
between the chain plates. Steam cleaning, high-
pressure washes, and certain solvents can dam-
age these O-rings. Use only kerosene to clean
the drive chain. Wipe it dry, and thoroughly lubri-
cate it with SAE 30 ~ 50 motor oil. Do not use
any other lubricants on the drive chain. They
may contain solvents that could damage the O-
rings.
1. O-rings
8-26
q
Upper wheel hub bolt:
50 Nm (5.0 m•kg, 36 ft•lb)
Lower wheel hub bolt:
50 Nm (5.0 m•kg, 36 ft•lb)
e
q
w
q
w