Filter
Top Products
8-15
5. Tap the element lightly to remove most of
the dust and dirt. Blow out the remaining
dirt with compressed air as shown. If the
air filter element is damaged, replace it.
6. Wash the foam cover gently but thor-
oughly in water or solvent.
7. Squeeze the excess water or solvent out
of the foam cover and let it dry.
CAUTION:
_
●
Do not twist the foam cover when
squeezing it.
●
Do not apply oil to the foam cover.
_
8. Inspect the foam cover. If damaged, re-
place it.
9. Install the foam cover onto the air filter el-
ement.
WARNING
POTENTIAL HAZARD
Using low flash point solvents or gaso-
line to clean the foam cover.
WHAT CAN HAPPEN
Low flash point solvents or gasoline can
catch fire or explode.
HOW TO AVOID THE HAZARD
Use parts cleaning solvent to clean the
foam cover.
U4XE16.book Page 15 Monday, March 24, 2003 3:14 PM