Filter
Top Products
PERIODIC MAINTENANCE AND MINOR REPAIR
6-37
1
2
3
4
5
6
7
8
9
5. Remove the socket (together with
the bulb) by turning it counter-
clockwise.
6. To remove the defective turn sig-
nal light bulb, push it in and turn it
counterclockwise.
7. To insert a new turn signal light
bulb into the socket, push it in, and
then turn it clockwise until it stops.
8. Install the socket (together with the
bulb) by turning it clockwise.
9. Place the turn signal light unit in
the original position, and then in-
stall the screws.
10. Install the windshield by installing
the screws.
11. Install panel A.
EAU34260
Replacing a rear turn signal
light bulb
1. Place the scooter on the center-
stand.
2. Remove cowling C for replacing
the left turn signal light bulb or
cowling D for replacing the right
turn signal light bulb. (See
page 6-8.)
3. Remove the socket (together with
the turn signal light bulb) by turning
it counterclockwise.
4. Remove the defective bulb by
pushing it in and turning it counter-
clockwise.
5. Insert a new bulb into the socket,
1. Screw
2. Front turn signal light unit
1. Turn signal light bulb socket
1
2
1
1. Turn signal light bulb socket
1