Filter
Top Products
INSTRUMENT AND CONTROL FUNCTIONS
4-17
4
5. Align the upper bolt holes in the
rider seat with the bolt holes in the
seat brackets, and then install the
bolts.
6. Install the passenger seat.
TIP
Make sure that the seats are properly
secured before riding.
EAU47351
Helmet holder
The helmet holder is located under the
passenger seat. A helmet holding cable
is provided in the owner’s tool kit to se-
cure a helmet to the helmet holder.
To secure a helmet to the helmet
holder
1. Remove the passenger seat. (See
page 4-14.)
2. Pass the helmet holding cable
through the buckle on the helmet
strap as shown, and then hook the
cable loops over the helmet hold-
er.
3. Place the helmet on the right side
of the vehicle, and then install the
passenger seat. WARNING! Nev-
er ride with a helmet attached to
the helmet holder, since the hel-
met may hit objects, causing
loss of control and possibly an
accident.
[EWA10161]
To release the helmet from the hel-
met holder
Remove the passenger seat, remove
the helmet holding cable from the hel-
met holder and the helmet, and then in-
stall the passenger seat.
1. Bolt
1
1. Helmet holder
2. Owner’s tool kit
3. Helmet holding cable
3
1
2
1. Helmet
2. Helmet holding cable
3. Helmet holder
1
2
3
U36P12E0.book Page 17 Monday, October 25, 2010 5:21 PM