Filter
Top Products
1
2
3
4
5
6
7
8
9
6-13
EAU1722A
PERIODIC MAINTENANCE AND ADJUSTMENT
1
2
1. Final transmission oil fi ller bolt
2. Final transmission oil drain bolt
4. Remove the oil fi ller bolt and drain
bolt to drain the oil from the fi nal
transmission case.
5. Install the fi nal transmission oil
drain bolt, and then tighten it to
the specifi ed torque.
Tightening torque:
Final transmission oil drain bolt:
13 Nm (1.3 m·kgf, 9.4 ft·lbf)
6. Refi ll with the specifi ed amount
of the recommended fi nal trans-
mission oil, and then install the
oil fi ller bolt and tighten it to the
specifi ed torque. WARNING!
Make sure that no foreign ma-
terial enters the fi nal transmis-
sion case. Make sure that no oil
gets on the tire or wheel.
[EWA11311]
Tightening torque:
Final transmission oil fi ller bolt:
23 Nm (2.3 m·kgf, 16.6 ft·lbf)
Recommended fi nal transmission
oil:
See page 8-1.
Oil quantity:
0.10 L (0.11 US qt, 0.08 Imp.qt)
7. Check the fi nal transmission case
for oil leakage. If oil is leaking,
check for the cause.
EAU20070
Coolant
The coolant level should be checked
before each ride. In addition, the cool-
ant must be changed at the intervals
specifi ed in the periodic maintenance
and lubrication chart.
EAUT1523
To check the coolant level
The coolant level should be checked
as follows before each ride. In addi-
tion, the coolant must be changed at
the intervals specifi ed in the periodic
maintenance and lubrication chart.
1. Place the vehicle on the center-
stand.
TIP
● The coolant level must be
checked on a cold engine since
the level varies with engine tem-
perature.
● Make sure that the vehicle is po-
sitioned straight up when check-
ing the coolant level. A slight tilt
to the side can result in a false
&')LQGG
ࣉࣟࢭࢫࢩࣥ ࣉࣟࢭࢫ࣐ࢮࣥࢱࣉࣟࢭࢫ࢚࣮ࣟࣉࣟࢭࢫࣈࣛࢵࢡ