Filter
Top Products
Windshield Mounting
•
Install the two suction cups and rubber bumper
o
nto the bracket by fitting them into their holes.
•
Press the suction cups onto the windshield at the
location you have chosen.
Important:
S
ome newer cars have a plastic safety
coating on the inside of the windshield. The
windshield bracket may leave permanent marks on
this type of surface. To find out if your vehicle has
this type of windshield, check the vehicle’s owner’s
manual or ask your dealer. We recommend that you
do not leave the suction cup bracket on the window
in direct sunlight. If the detector is removed, this
may cause blistering of the dash in some
vehicles.
• Slide the detector onto the bracket until it locks into
place.
• If necessary, the unit may be leveled by bending
the windshield bracket. Press the bracket release
button and remove the detector before bending.
INSTALLATION OPERATION
6
7
R
ubber
B
umper
Power Cord Connection
•
Plug the small end of the power cord into the
u
nit’s power jack.
•
Plug the large end into the vehicle’s cigarette
lighter socket.
N
N
o
o
t
t
e
e
:
:
Cord fits tightly into detector. When
installing the cord, expect some resistance.
Fuse Replacement
T
he lighter socket plug is equipped with a
replaceable 2 amp, 3AG fuse located behind the
silver tip. To replace the fuse, carefully unscrew
the tip of the plug.
I
I
m
m
p
p
o
o
r
r
t
t
a
a
n
n
t
t
:
:
Unscrew slowly. The tip contains a
spring which may fly out when disassembling.
Insert the new fuse with the spring and screw on
the tip. With use, screw cap on plug may loosen.
Retighten occasionally.
Power On, Self Test
To turn the unit ON or OFF, push the center of
the Power/Volume button.
Each time your Whistler detector is turned on,
an automatic self-test sequence confirms that
the speaker and visual displays are functional.
•
Display shows in order:
1. WHISTLER 2. X-band 3. K-band 4. Ka-band
5. LASER ON 6
.
.
SR OFF 7. VOICE ON
8. POP ON 9. B SVR ON 10. FILTER 11. HIGHWAY
Audio Level Adjustment
To change the audio level:
•
Move Power/Volume button back to increase
a
udio level.
•
Move Power/Volume button forward to
decrease audio level. As audio level is
adjusted, beeps are provided and the display
indicates volume level.
Auto Quiet Mode
Auto Quiet mode reduces the selected audio level
to level (1) appro
ximately 5 seconds after a radar or
safety radar signal is detected. The alert for any
new signal within 20 seconds will re
sume at level (1).
A
uto Quiet mode does not af
fect laser alerts.
• Pr
ess Quiet (befor
e a signal is detected) to
engage Auto Quiet mode.
• Once the Auto Quiet mode is engaged, you
may cancel the audio alar
m by pressing Quiet.
• Press Quiet (when the unit is not alarming) to
cancel Auto Quiet mode.
Quiet Mode
Quiet mode cancels audio during an alert and any
new
alert within 20 seconds. After 20 seconds of no
radar signal detected, the audio alerts are
restor
ed.
• Press Quiet to cancel the audio.
• Press Quiet a second time during an alert to
restore the standard audio alert pattern.
OPERATION
8