Filter
Top Products
OPERATION OPERATION OPERATION OPERATION
Engaging/Disengaging VG-2
Pro-73: See option select mode to turn this feature on.
Pro-58: Press and hold the quiet button. Unit beeps
once for VG-2 on, twice for off.
When a VG-2 signal is detected, the VG-2 alert is
sounded. After 3 seconds the audio is cancelled and
the VG-2 indicator flashes at a slower rate. This cycle
is repeated if the VG-2 signal is again detected.
During the period a VG-2 signal is detected, a radar
signal cannot be detected. However, because the VG-2
alert has confirmed that a patrol car is nearby, you are
already aware of the potential for speed monitoring
and can adjust your speed accordingly. Laser detection
is not affected while a VG-2 signal is detected.
Teach/Tutorial Mode
Provides simulated alerts for each type of signal.
• Press City and Quiet simultaneously and release.
• Press Power to exit.
10 11
Option Select Mode (Pro-73 Only)
Entering Option Select Mode allows you to customize options
such as Tone Select, Abbreviated Power Up Sequence and
VG-2 Mode. When selecting options, the , or quiet
must be pressed within 20 seconds or options mode will
automatically be exited. To enter:
Pro-73 Chart
Press: Display To Change: Option:
Quiet Reads:
1st Time TONE 3 = YES Tone 1, 2, 3
= NO (3 different X, K, Ka
Patterns)
2nd Time TEST YES = ON X, K, Ka Audio tones
= OFF 1 beep during
Power Up
3rd Time VG-2 OFF = ON Turns VG-2 On
= OFF Turns VG-2 Off
4th Time SR ON = ON Turns Safety Radar
= OFF On
5th Time VOICE ON = ON Real Voice Engaged
= OFF Real Voice
6th Time POP ON = ON POP On
= OFF POP Off
7th Time B SVR ON = ON Battery Saver On
= OFF Battery Saver Off
12 13
Vehicle Battery Saver Mode
The Vehicle Battery Saver Mode automatically shuts off
your detector within 3 hours if you forget to turn it off. The
timer is reset if the detector is turned off, unplugged or any
button is pressed before the 3 hours have expired. The detector
will alert you with an audible and visual warning before
it shuts off.
During this warning you can reset the unit by pressing
any button. This will reset the timer.
If the unit has automatically turned itself off, press the Power
button to turn the unit back on. You can manually engage
the Vehicle Battery Saver Mode by pressing and holding
the City button until one beep is heard.
Refer to “Option Select Mode” for instructions for
deactivating battery saver mode feature. (Pro-73 Only)
Stay Alert Feature
The Stay Alert Feature is designed to test a driver’s
alertness. To engage (when unit is not alarming) :
• Press and hold City for approximately 2 seconds.
Release button during or immediately after the alert
is given.
—Pro-73 only: Display reads:
Within 30-60 seconds two beeps are sounded; to
show alertness, the driver must press either the City,
Volume, or Quiet buttons within 3-5 seconds. If a button
is pressed within 3-5 seconds, the cycle is repeated.
If a button was not pressed within 3-5 seconds alarm
sounds and the display reads:
—Pro-58 only: The “H” or “C” will flash indicating
Stay Alert is activated.
Within 30-60 seconds two beeps are sounded; to
show alertness, the driver must press either the
Volume, City or Quiet button within 3-5 seconds.
If the button is pressed within 3-5 seconds, the cycle is
repeated. If a button was not pressed within 3-5 seconds,
alarm sounds and the display will flash all LED’s.
• Press Power to exit for both the Pro-58 & Pro-73.
Stay Alert Feature (Cont.)
WARNING!!! Stay Alert is NOT intended as a substitute
for adequate rest. You should NOT operate a vehicle if you
are drowsy. During extended periods of vehicle operation,
you should take frequent breaks. Improper reliance on the
Stay Alert feature may result in vehicle damage, personal
injury or death. NEVER OPERATE A VEHICLE IF YOU
ARE DROWSY.
Safety Warning System™
In communities where transmitters are located,
the Safety Warning System
™
displays over 60 text
messages. When Safety Radar is detected the audio
alert is geiger counter-like.
Safety Warning System Text (Pro-73 Only)
Example: Poor - Road - Surface.
• Pro-58 Model displays a to indicate a SWS
™
message has been received.
NOTE:
Not all areas have Safety Warning System
™
transmitters.
SWS
™