Automatically storing a station
Pressing AUTO (7) automatically searches for and stores up to ten strong AM or FM stations in a
separate memory. If more than ten stations are found, the ten strongest ones are stored. This function is
especially useful in areas in which you are not familiar with radio stations or their frequencies.
To use the AUTO function:
● Select a waveband using the AM/FM button (1).
● Start the search by pressing AUTO until AUTO STORING appears in the display.
● When the search is completed, AUTO STORING will no longer be displayed. If there are no stations
with sufficient signal strength, NO AST FOUND is displayed.
The auto-stored stations can be selected using the preset buttons (2).
Press EXIT (6) to terminate the automatic storing function.
When the radio is in auto-store mode, AUTO is shown in the display. AUTO disappears when you
return to normal radio mode, which can be done by briefly pressing AM/FM (1), EXIT (6), or AUTO
(7).
pg. 175 Radio functions
To return to the Auto-store mode, press the AUTO button briefly and select a stored station by pressing
one of the preset buttons (2).
Saving auto-stored stations in the preset memory
An auto-stored station can be saved in the memory for manually preset stations.
● Press AUTO (7) briefly. Auto is displayed.
Press one of the preset buttons (2) under which the station is to be stored. Hold down the button until
STATION STORED is displayed.
The radio will then exit auto-store mode and the stored station can be selected by pressing the preset
button.
Scanning
SCAN (4) automatically searches through the selected waveband for strong AM or FM stations. When
the radio finds a station, that station will be played for approximately 8 seconds, after which scanning
resumes.
Activating/deactivating SCAN
● Select radio mode using the AM/FM button (2).
