Filter
Top Products
VIVOTEK
10 - User's Manual
1. Connect 12V DC power and an Ethernet cable to the network. The camera can also be
powered by a PoE connection (up to 11.5W).
2. If preferred, install an SD/SDHC/SDXC card.
3. Connect DI and DO devices. The max. load on a DO pin is 50mA.
SD
LAN / WAN
Reset
LEDs
DI/DO
Item LED Status Description
1 Steady Red Power on and system booting
Red LED off Powered off
2 Steady Red + blinking Green every 1 sec. (Green
LED on for 1 sec and off for another)
Network heartbeat
Steady Red + Green LED off Network disconnected
3 Blinking Red every 0.15 sec. + Blinking Green
every 1 sec. (Red LED on for 0.15 sec. and Green
LED on for 1 sec. and off for another)
Upgrading rmware
4 Blinking Red every 0.15 sec. + blinking Green
every 0.15 sec
Restoring defaults