Viper 671XV Automobile Alarm User Manual


 
11
© 2004 directed electronics, inc.
second chirp after arming and note that the in-vehicle’s status
LED is flashing in groups, see the Diagnostics Section of this
guide. This extra chirp is called Bypass Notification.
The remote responds to active arming with one beep and the
Orange LED will flash 3-times to indicate successful arming of
the system.
If after 2-seconds the remote beeps once and the Orange and
Red LEDs flash 3-times, the system has detected an active sensor
that should be checked.
If after 2-seconds the remote beeps once, the Orange LED flashes
6-times and the Red LED lights for 3-seconds, the system has
detected an open door, hood or trunk and has been bypassed.
passive arming
The system can be programmed to arm itself automatically (called
passive arming). If the system is programmed for passive arming, it
will automatically arm 30 seconds after the ignition is turned off
and the system detects that you have left the vehicle by opening and
closing a door. Whenever the system is in its 30-second passive
arming countdown, the in-vehicle status LED will flash twice as
fast as it does when the system is armed. At the 20-second point of
the countdown, the siren will chirp to indicate that the system is
about to arm. At the 30-second point, the parking lights will flash
to indicate that the system is armed.