Filter
Top Products
12
©
2000 Directed Electronics, Inc.
When you are ready to drive the vehicle:
1. Insert the ignition key and
turn it to the ON (not the
START) position.
2. Press the brake pedal.
NOTE: If the brake pedal is pressed before the key is in the ON position,
the engine will shut down.
While the vehicle is running during remote start operation, the
system will monitor the vehicle and will automatically shut down the
engine if the system receives any of the following shut-down inputs:
■ The brake pedal is pressed.
■ The hood is opened.
■ The shutdown toggle switch is put into the OFF position.
■ The pre-programmed run time (12, 24, or 60 minutes) has elapsed.
■ Transmitter buttons and are pressed again to start the
vehicle.
To shut down the remote start and turn off the engine:
■ Step on the brake pedal, or
■ Press and for one second.
The Valet
®
Take-Over feature allows the vehicle to remain running
after the key has been removed from the ignition. This feature is
useful for occasions when you wish to exit and lock the vehicle for
short periods of time, but would like to leave the motor running
and the climate controls on.
Valet
®
Take-Over