Viper 550HF Automobile Alarm User Manual


 
19
QUICK REFERENCE OPERATING CARD:
Arming
You can turn on, or arm, the system by pressing Button I of your
transmitter for one second. When the system arms, you will hear a
short chirp, and see the parking lights flash once.
Arming While Driving
Press Button I on your transmitter while the vehicle is running. The
system will chirp once and then once more to indicate that the igni-
tion is on.
Disarming
Press Button I. You will hear two chirps, and the parking lights will
flash twice.
High Security Disarm
Press Button I on your transmitter.The siren will stop sounding. Next
press Button I once more and the system will chirp four or five times
(reporting the trigger) and disarm.
Disarming Without a Transmitter
Turn on the ignition. Push the Valet switch
within 15 seconds.
The
system should now disarm. If it does not, you may have waited too
long, so turn the ignition off and on and try again.
Silent Mode
TM
Press Button II briefly before arming or disarming, and the confirma-
tion chirp(s) will be eliminated for that one
operation only.
Panic Mode
Press Button I for 1.5 seconds, and you will enter Panic Mode.The
siren will sound and the parking lights will flash for 30 seconds. To
stop Panic Mode at any time, press Button I on the transmitter
again.
To enter or exit Valet
®
Mode with the Valet switch:
Turn ignition to "run" position, then turn to "off" position. Press and
release the Valet switch within 10 seconds.The Status LED will light
steady if you have entered Valet Mode, and go out when you exited.
Using Remote Valet as you enter or exit the vehicle:
Press Button I. Press Button II. Press Button I again. The Status
LED will light steady if you have entered Valet Mode,and go out if
when you exited.
Cut along dotted line and fold where indicated for a quick and easy reference to keep in your purse or wallet.