Filter
Top Products
16
5.Charge the unit until the green CHARGED indicator is lit when the Charge Status Button is
pressed - DO NOT EXCEED 8 HOURS MAXIMUM.
6.After charging, disconnect the cables and store them in the Cable Storage Hatch.
7.3 ALTERNATE DC RECHARGE
If the Inverter is removed from the Main Unit, the DC Recharge Cable can be directly connected
to the black power connector that mates with the Inverter's flat power pins. In this way, the
Inverter and Inverter Power Cable can be used away from the Main Unit and DC Recharge can
be accomplished. Follow the same charging time and monitor the battery charging by using the
Battery Status Push-button and Display.
7.4 SIMULTANEOUS DC RECHARGE AND INVERTER OPERATION
Connecting the Inverter Power Cable and the DC Recharge Cable makes a heavy-duty DC-to-
DC Cable that can simultaneously recharge the Main Unit and operate the Inverter while it is
mounted on Power City. Plug One DC Plug into Power City Accessory Socket and the other DC
Plug into a vehicle accessory socket. When using with AC appliances that draw over 120 watts
and at the same time the Power City’s Battery is deeply discharged, this could draw more than
the vehicle's accessory socket's fuse can handle and result in a blown fuse. Use this method with
caution. Periodically monitor DC recharge using the Battery Status Pushbutton and Indicators.
8. MAINTENANCE/REPLACEMENT PARTS
For replacement parts (bulbs, batteries, charging adapters, cables, etc.), contact Vector
Technical Support: (954) 584-4446 or call toll-free (866) 584-5504. Except for a fuse in the
inverter and a lamp in the Lantern, there are no user serviceable parts inside Power City.
Periodically, the cables and connectors should be inspected for damage, corrosion and dust
and dirt. If surfaces are dirty, they can be wiped clean with a cloth moistened with water and a
small drop of detergent. Contacts can be wiped clean with a dry cloth.
WARNINGS: Other than a fuse in the inverter and a lamp in the lantern, there are no user
serviceable parts inside. DO NOT operate unit if there is any evidence of damage. The
product must be returned to vector for testing and repair. Replace any damaged cables
immediately before further use.
Refer to section 4.6 for inverter fuse replacement. Refer to section 6.4 for lamp replacement.
9. BATTERY DISPOSAL
Contains a maintenance-free, sealed, non-spillable, lead acid battery, which must be disposed
of properly. Recycling is required. Contact your local authority for information. Failure to
comply with local, state and federal regulations can result in fines, or imprisonment. Sealed
lead battery, must be recycled or disposed of properly. For more information on recycling this
battery, call toll-free 877/288-7722.
BATTERY DISPOSAL WARNINGS:
• Do not dispose of the battery in fire as this may result in an explosion
• Before disposing of the battery, protect exposed terminals with heavy-duty electrical tape to
prevent shorting (shorting can result in injury or fire)
• Do not expose battery to fire or intense heat as it may explode
ALWAYS RECYCLE
PRBA
PRBA