Filter
Top Products
6
INDICATORS
THE LARGE 3-CHARACTER DIGITAL DISPLAY in the upper left hand corner of the panel indicates many conditions.
It indicates when AC power is applied to the charger, actual charge rate in amperes, when the battery is fully
charged, detected faults, operating modes and when the charger is ready for the next mode selection. What is
displayed are called “status codes”. They are described below (Figure 5) and on the rear of the charger, for
handy reference.
FIGURE 5
Below the Digital Display are a series of four LEDS that light on the following conditions:
FAULT - lights when a any of several faults are detected - see F01 through F05 Codes as described
above (If the Fault LED lights, refer to TROUBLESHOOTING for details)
REV POLARITY - Lights when the clamps are connected to incorrect polarity. Charging Complete lights
at same time the digital display shows”FUL”.
CHARGING COMPLETE - Indicates Battery is charged
ALTERNATOR GOOD - lights when this particular load check shows the alternator is keeping up with
the electrical load.
VEC093
A062003