Univex Trail Blazer Offroad Vehicle User Manual


 
47
OPERATION
Starting the Engine
Starting a Cold Engine
WARNING
Engine exhaust contains poisonous carbon monoxide and can
cause loss of consciousness resulting in severe injury or death.
Never run an engine in an enclosed area.
CAUTION
Operating the vehicle immediately after starting could cause
engine damage. Allow the engine to warm up for several minutes
before operating the vehicle.
1. Place the transmission in neutral and
lock the parking brake. Make sure the
fuel valve is on.
2. Sit on the vehicle and pull the choke
knob (1) out until it stops.
NOTE: If the knob doesn’t stay where
positioned, increase the tension by
rotating the tension adjusting nut (2)
clockwise.
NOTE: The variable choke is fully on when
the knob is pulled completely out.
The choke is off when the knob is
pushed completely in. The choke
can be adjusted gradually, depending on how much choke is
needed for starting. Be sure the choke is off during
operation, as excess fuel washing into the engine oil will
increase wear on engine components.
3. Move the engine stop switch to RUN.
NOTE: Do not press the throttle while starting the engine.
4. Turn the ignition key past the ON position to engage the starter for
a maximum of five seconds. Release t he key when the engine
starts. If it doesn’t start, release the key and wait five seconds.
Activate the starter for another five seconds. Repeat until the
engine starts.
5. If the engine slows or stops, position the choke knob half way in to
allow proper engine warm up.
6. Vary the engine RPM slightly with the throttle to aid in warm-up.
When the engine idles smoothly, push the choke all the way in.
1
2